6.
2
.
Turning on.
Before inserting the battery into the tool, always check to see that the switch
trigger returns to the "OFF" position when released.
6.
2
.1.
To start the tool, simply pull the switch trigger
(1)
. Tool speed is
increased by increasing pressure on the switch trigger. Release
the switch trigger to stop.
6.
3
.
LED Lamp.
Do not look in the
LED
light directly.
6.
3
.1.
Pull the switch trigger to light up the
LED (1)
.
6.
3
.2.
The lamp will stay ON whilst the switch trigger is being pulled.
The lamp goes out 10 -15 seconds after releasing the trigger.
6.
3
.3.
NOTE: Use a dry cloth to wipe the dirt off the lens of lamp.
6.
3
.4.
Be careful not to scratch the lens of lamp, or it may lower the
illumination.
6.
4
.
Reversing switch.
Always check the direction of rotation before operation.
Use the reversing switch only after the tool comes to a complete stop. Changing
the direction of rotation before the tool stops may damage the tool.
When not operating the tool, always set the reversing switch lever to the neutral
position.
6.
4
.1.
This tool has a reversing switch
(1)
to change the direction of
rotation. Depress the reversing switch lever from the side for
clockwise rotation or from the B side for counter clockwise
rotation.
6.
4
.2.
When the reversing switch lever is in the
middle
position, the
switch trigger cannot be pulled.
Page 9