5.2.1.
The tool will automatically stop during operation if the tool and/or battery are placed under
one of the following conditions;
5.2.1.1.
Overloaded: The tool is operated in a manner that causes it to draw an abnormally
high current. In this situation, release the switch trigger on the tool and stop the
application that caused the tool to become overloaded. Then pull the switch trigger again
to restart. If the tool does not start, the battery is overheated. In this situation, let the
battery cool before pulling the switch trigger again.
5.2.1.2.
Low battery voltage: The remaining battery capacity is too low and the tool will not
operate. In this situation, remove and recharge the battery.
6. QUICK REFERENCE
1
1/2" Drive socket
2
LED light
.
3
Trigger/variable
speed control
.
4
Battery unlock
button
.
5
Battery
.
6
Direction switch
.
7
Hook
.
6.1.
Fitting 1/2" drive sockets
.
Always be sure that the tool is switched off and the battery cartridge is removed
before carrying out any work on the tool.
6.1.1.
Lock off the trigger and remove the battery before continuing. (central position of forward/
reverse switch).
6.1.2. To fit the 1/2” drive sockets slide the socket over the drive socket adapter until it clicks into
place. (*sockets not supplied)
5.2. Battery protection system.
Page 8