Hyundai HY2155, User Manual

Page: 8 / 16

Page 8
5.2.1. The tool will automatically stop during operation if the tool and/or battery are placed under
one of the following conditions;
5.2.1.1. Overloaded: The tool is operated in a manner that causes it to draw an abnormally
high current. In this situation, release the switch trigger on the tool and stop the
application that caused the tool to become overloaded. Then pull the switch trigger again
to restart. If the tool does not start, the battery is overheated. In this situation, let the
battery cool before pulling the switch trigger again.
5.2.1.2. Low battery voltage: The remaining battery capacity is too low and the tool will not
operate. In this situation, remove and recharge the battery.
6. QUICK REFERENCE GUIDE and USE
1 Chuck Jaws. 2 Keyless Chuck.
3 Torque Setting -Drill
collar. 4 Speed Selector
Switch.
5 Auxiliary Handle.
6 Trigger Switch.
7 Battery Unlock
button.
8 Battery Pack. 9 Reversing Switch. 10 Hook.
6.1. Installing side grip (auxiliary handle).
Always be sure that the tool is switched off and the battery cartridge is removed
before carrying out any work on the tool.
6.1.1. Always use the side grip to ensure operating safety. Insert the side grip so that the
protrusions on the grip base and steel band fit in between the grooves on the tool barrel. Then
tighten the grip by turning clockwise. When you turn the side grip, loosen and remove the
grip, then turn the grip and insert it again. N.B. Rotate clockwise to tighten and anticlockwise
to loosen.