11
5.0
Turn the ignition switch to the OFF position.
6.0
To determine the correct working pressure and air flow requirements for any piece
of equipment, check the corresponding manual.
6.1
Be aware that the air flow figure stated on tools and accessories refers to ‘free air
delivery’ and not the piston displacement of the compressor.
6.2
When adjusting the regulator, always adjust up to the required pressure.
6.3
After fitting the desired coupling to the outlet valve, connect an air hose and hook up
to an air system.
An outlet regulator is necessary to use air equipment direct from the compressor.
6.4
At the end of each working day, drain any moisture from the main tank.
6.5
Place a container under the drain plug and then carefully unscrew it anti-clockwise.
6.6
DO NOT allow moisture to accumulate in the tank as this will corrode the inside of
the tank and affect the pressure rating of the tank.
WARNING
Service and maintenance must be performed by an authorised agent.
DO NOT tamper with, or attempt to adjust the pressure switch or safety valve.
Before moving or carrying out any maintenance on the compressor, make sure that
the ignition switch is OFF, the air tank pressure has been vented and that the
compressor has been allowed to cool down for a period of time.
Failure to carry out maintenance tasks, may invalidate the warranty on your
compressor.
7.0
In order to keep the compressor in good working condition, periodic maintenance
is essential.
Operations to be carried out after the first 60 hours of use.
7.1
Check that all nuts and bolts are tight, particularly those retaining the crank case and
cylinder head.
7.2
Replace the lubricating oil.
Operations to be carried out daily.
7.3
Drain condensation by opening the valve located under the tank.
5. STOPPING PROCEDURE
6. USING THE MACHINE
7. MAINTENANCE
Summary of Contents for HY140200PES
Page 1: ...1...
