Hyundai HY10000LEK-2, User Manual

Page: 15 / 28

Exhaust system heat and/or gases could ignite combustible, structures or damage the fuel
tank causing a fire, resulting in death, serious injury and/or property damage. Contact with
muffler area could cause burn resulting in serious injury.
DO NOT touch hot part and AVOID hot exhaust gases.
You MUST a llow the equipment to cool before touching.
Keep at least 5 feet (152 cm) of clearance on all sides of generator including overhead.
IMPORTANT DO NOT overload the generator. DO NOT overload individual output sockets.
These outlet sockets are protected against overload with push-to-reset-type circuit
breakers. If current rating of any circuit breaker is exceeded, that breaker will open and the
electrical output to that socket will be lost.
5.3. Connecting electrical loads.
5.3.1. Let the engine run until the rpm is stable and has been allowed to warm up for a
few minutes after starting.
5.3.1.1. T hen plug in and turn on the electrical loads.
5.3.1.2. Add up the rated watts (or amps) of all loads to be connected
at one time. This total should not be greater than;
5.3.1.2.1. The circuit breaker rating of the output socket supplying the power
or,
5.3.1.2.2. The rated wattage/current capacity of the generator.
Connect all electrical loads in the OFF position then turn ON for operation.
Turn all electrical loads OFF and disconnect from generator before stopping generator. #
Exceeding generators wattage/current capacity could damage generator and/or electrical
devices connected to it.
DO NOT exceed the generator’s wattage/current capacity.
# Failure to disconnect the electrical load before switching the generator OFF may
damage the AVR.
5.4. Overloading.
5.4.1. Overloading a generator in excess of its rated wattage capacity can result in
damage to the generator and to connected electrical devices.
5.4.2. Observe the following to prevent overloading of the unit;
5.4.2.1. Add up the total wattage of all electrical devices to be connected at one
time. This total should NOT be greater than the generator’s wattage
capacity.
5.4.2.2. The rated wattage of lights can be taken from light bulbs. The rated
wattage of tools, appliances and motors can usually be found on a data
label or decal affixed to the devices. If the appliance, tool or motor does
not give wattage, multiply volts times ampere rating to determine watts
(volts × amps = watts).
Page 15 Ver 2 - December 2016