Hyundai H-VCA01, Instruction Manual

Page: 6 / 17

6.

Never use the appliance without dust bin. Replace the dust bin without delay if it is
damaged.

Do not attempt to repair, adjust or replace parts in the appliance. Repair the
malfunctioning appliance in the nearest service center.

If the product has been exposed to temperatures below 0 ºC for some time it
should be kept at room temperature for at least 2 hours before turning it on.

The manufacturer reserves the right to introduce minor changes into the product
design without prior notice, unless such changes influence significantly the
product safety, performance, and functions.

Production date mentioned on the unit and/or on the packing materials and
documentations.
VACUUM CLEANER ASSEMBLING

Remove all packing materials and stickers from the vacuum cleaner.

Insert the flexible hose into the air inlet and press until it clicks into proper
position.

Using the length adjuster, pull out the telescopic tube to the desired length and
lock it.

Insert the hose into the tube.

Attach a nozzle to the tube: Floor brush is intended for cleaning bare floor and
floor coverings. Crevice nozzle is for cleaning between cushions. Sofa brushes are
for cleaning sofas and cushions.

Remove the water tank. To remove the tank, push the latches located on the
housing and pull the tank handle up.

Open the water tank. To open the tank, push the latches located on the tank sides
and pull out the lid using the tank handle.

Fill the tank with water (the maximum allowed water level is denoted with "MAX"
mark).

If, at the beginning of operation or during moisture collection, the water level in
the container exceeds the normal level, the float switch sends a signal to the
control unit, and the device will stop automatically.

To close the container properly, use slots (grooves) inside the container and slide
it along the edges of internal lid surface.

Attention: Incorrect use of the container may lead to its damage.

Place the tank on the housing.
INSTRUCTION FOR USE

Before starting, unwind the cord to sufficient length and insert the plug into the
power supply. The yellow mark on the cord shows optimal cord length. Do not
unwind the cord beyond the red mark.

Press On/Off button to switch the unit on and press again to stop it.

You can adjust the air flow using the air flow regulator on the flexible hose handle:
Decrease flow for cleaning curtains, books, furniture, etc.Increase flow for
cleaning bare floor.

The housing is equipped with the display and sensor power level regulator used to
adjust sucking force.