Hyundai H-SA1004, Instruction Manual

Page: 2 / 15

2
Before you start
Dear customer!
Thank you for purchasing our product. For safety, it is strongly recommended to read
this manual carefully before connecting, operating and/or adjusting the product and keep
the manual for reference in the future.
If you want to dispose this product, do not mix it with general household waste. There is
a separate collection system for used electronic products in accordance with legislation
that requires proper treatment, recovery and recycling.
Please contact your local authorities for the correct method of disposal. By doing so, you
will ensure that your disposed product undergoes the necessary treatment, recovery and
recycling and thus prevent potential negative effects on the environment and human health.
Utilization of the product
Important safeguards
• If after reading the directions you feel
uncomfortable about installing the amplifier in
your car, or not equipped or competent to do
so, you should have the amplifier installed by
an authorized installer. It's your car!
• The negative battery terminal must be
disconnected before any electrical connections
are made.
• Be sure to choose a location that provides
substantial ventilation for the amplifier. The
most preferred locations would be in your car's
trunk, under the front seats or on the back wall
of a truck.
• The location chosen should provide at
least 2 inches of clearance above the amplifier
for adequate ventilation.
• If the amplifier is to be mounted vertically
be sure that it is in a place where adequate air
will flow along the length of its heatsink fins for
cooling.
• Never mount the amplifier up side down,
this will cause the heat to rise back into the
amplifier causing thermal shutdown or possible
permanent damage.
• Never mount the amplifier in a location
that is subject to direct sunlight or exposed to
moisture.
• Be sure to mount the amplifier to a strong,
solid surface which will not give way under the
stress of a sudden stop or accident.
• Make sure that the mounting screws will
not penetrate the gas tank, brake and fuel
lines, wiring or other critical parts of your car
when installed.
• Never operate the amplifier without the
proper power and ground wire 10 gauge
minimum.
• Never operate the amplifier without proper
fusing. Fuse holder must be located with in 0.5
meters from the battery. This fuse is to protect
the car not the electronics. In case of a short,
the fuse will blow instead of the wire burning
up. Using other than the recommended fuse
ratings at the battery and at the amplifier may
cause damage to the amplifier and will void
your warranty.