Troubleshooting
Below is a table describing simple measures that can help you eliminate most problems likely to
emerge when this unit is in use. If below measures do not help, turn to a service center.
Symptom
Cause
Solution
No power
The car ignition is not on.
If the power supply is properly connected
to the car accessory switch the ignition
key to “ACC”.
The fuse is blown.
Replace the fuse.
No sound
Volume is in minimum.
Adjust volume to a desired level.
Wiring is not properly connected. Check wiring connection.
Bad sound
quality
The installation angle is more
than 30 degrees.
Adjust the installation angle to less than
30 degrees.
The disc is extremely dirty or
defective.
Clean the compact disc/try to play a new
one.
Disc cannot
be loaded or
ejected
The unit already contains a disc.
Remove the disc in the player then put a
new one.
Moisture condensation.
Leave the unit idle for an hour, then retry.
Disc cannot be
read
The disc is inserted upside
down.
Insert the compact disc with the label
side facing upward.
Compact disc is extremely dirty
or defective.
Clean the disc or try to play a new one.
Temperature inside the car is
too high.
Cool off until the ambient temperature
returns to normal.
Buttons do not
work
The built-in microcomputer is not
operating properly.
Reset the unit with the help of RESET
button.
Front panel is not properly fix
into its place.
Install the front panel properly.
The radio does
not work
The antenna cable is not
connected.
Insert the antenna cable properly.
The radio
station
automatic tuning
does not work
The signals are too weak.
Select stations manually.
18
General information
