Hyundai H-1613, Instruction Manual

Page: 4 / 13

4
Instruction manual
frequency increases or decreases 9 KHz.
Store Scan
In receiving state, press PRESET/ALARM
button once, it will begin to scan station.
In the course of searching, when there is
a station, it will store it automatically, and
then continue. In the course of automatic
scanning, press PRESET/ALARM button
again, it will stop scanning.
• In the course of automatic
scanning, if not clear, please change to
use manual to search station.
• When using the store scan function,
the old frequency will be covered with the
new station
Store Stations
• You can use one of the methods of
auto, manual and direct input station to
receive station frequency.
• Press MEMO button, “PRESS” is
flashing on the display.
• Press M+ or M- button within 5
seconds to select stored address. Press
MEMO button again to confirm the stored
address, the station frequency has been
stored in the address.
You can store 10 stations in each
band. If in 1-10 address the station
frequency already exists, store new
frequency according to the above-
mentioned methods, the old frequency
will be cancelled.
Using Stored Stations
In receiving state, press BAND/MODE
button to select band, press M+ or M-
button to select the station which is saved
in the memory.
General operations
Power Switch
Press POWER button once to turn on
the radio; the last band frequency before
turning off the radio is displayed. Press
POWER button again to turn off the radio;
the time is displayed.
Adjust Volume
• The radio is with electric volume
function; do not listen with highest volume.
The volume can be set and stored.
• In receiving state, press VOL+/VOL-
buttons to adjust volume, you can select
your desired volume.
Lock Switch
The button lock switch is set in the
radio to avoid mis-operation. Before use,
please check the lock function.
After selecting the station or turning
off the radio, please press LOCK button,
the lock indicator will be displayed. The
buttons will not function now.
Earphones Socket
For private listening please insert the
earphones in the earphone socket (the
speaker inside the radio disconnects
automatically), you can listen to the radio
by earphones.
Button Illumination
All the buttons have illumination
function. Press any of them, and the lamp
lights up; it will automatically go out after
several seconds, which is convenient for
you to operate the radio in darkness.
Supporting Buckle
It is convenient for you to place the radio.
Reset Button
The microcomputer chip is used to
handle radio signal in the unit. When you
change battery or change-over external
power, mis-operate, or the radio is
jammed, the microcomputer chip in the
unit may come into in the state of dead
cycle, it is out of order. At this time only