6
Instruction manual
Cassette recording
Insert a blank cassette with the tape-side
up. Close the cassette compartment. The unit
is now ready to start recording, which can be
done from either the radio or CD.
Recording from radio
• Set FUNCTION switch to RADIO position.
• Select a band and tune to the desired
station by pressing NEXT/TUNE-UP or BACK/
TUNE-DOWN buttons.
• Press button and button
simultaneously to start recording.
Recording from CD
• Set FUNCTION switch to CD position.
• Press and buttons at the same time to
start recording, then press button.
• Start the CD and select a song to be
recorded.
• Release button to start recording.
USB operations
• This unit is equipped with a USB socket
which can accept and play MP3 files stored
on standard USB flash (compatible with USB
version 1.1 & 2.0) up to 4 Gbs.
• To use USB drives for MP3 playback insert
the USB drive into the appropriate socket and
press STOP/CD/USB/FM MODE button on the
unit or CD/USB button on the RC.
• If MP3 files are found the set will start
playback of the first file.
• Playback control is same as for discs.
Always switch off the unit or change
mode to “CD” or “RADIO” before removing a
USB flash drive.
Attention:
Although this product is fully
compatible with USB 1.1 & 2.0 standard
formats, a small percentage of USB flash
drives might not be readable, due to those
device manufacturers’ non-compliance with the
full (official) USB standards.
Dynamic bass boost system
• The built in “super bass booster” circuit
provides a powerful enhancement to low
frequency music, giving a stronger bass sound
which is ideal for “rock” or “jazz” music.
• For increased bass at all volume levels,
set BASS BOOST switch into “On” position for
an emphasized bass sound.
Maintenance and care
• Check your batteries regularly, old or
discharged batteries should be replaced. If the
unit is not going to be used for some time or is
being run exclusively on the alternative power,
remove the batteries to avoid leakage and
damage.
• Electronic products of this kind should
never be subjected to moisture or extreme
temperatures.
• Do not use the unit in places where it can
be exposed to water, moisture and dust.
• If necessary, clean the unit with a piece of
cloth dampened with water only (be sure the
AC power cord is disconnected from the power
supply).
• The heads and capstan are in constant
contact with the moving tape. Use a small
cotton bud with alcohol or special tape head
cleaner to clean these parts. Never touch the
heads with anything metallic.
• When pick up the CD disc, always hold the
edge of the disc, never touch the surface of the
disc, it would scratch the disc surface and may
occur sound distortion or raise reading problem.
Erase protection
• To prevent accidental erasing of a
cassette, simply break off the two plastic tabs
located on the cassette tape’s rear side.
• When a cassette with removed plastic
tabs is inserted, the recording button cannot be
pressed.
• If a cassette is to be erased and re-
Summary of Contents for H-1424
Page 15: ......
