Hyundai 2010 GENESIS COUPE, Manual

Page: 4 / 103

Water leak through windshield
end rear window Defective seal Fill with sealant
Defective flange Correct
Body (Interior and Exterior) > Body Dimensions > General Information
General
1. Basically, all measurements in this manual are taken with a tracking gauge.
2. When a measuring tape is used, check to be sure there is no elongation, twisting or bending.
3. For measuring dimensions, both projected dimension and actual-measurement dimension are used in this manual.
Measurement Method
Projected Dimensions
1. These are the dimensions measured when the measurement points are projected into the reference plane, and are
the reference dimensions used for body alterations.
2. If the length of the tracking gauge probes are adjustable, make the measurement by lengthening one probe by the
amount equivalent to the difference in height of the two surfaces.
Actual-Measurement Dimensions
1. These dimensions indicate the actual linear distance between measurement points, and are the reference
dimensions for use if a tracking gauge is used for measurement.
2. Measure by first adjusting both probes to the same length (A=A').
Check the probes and gauge itself to make sure there is no free play.