P a g e
| 25
7) If the choke lever was moved to the 'CLOSED' or 'START' position to start the
engine, gradually move it to the 'OPEN' or 'RUN' position once the engine
warms up.
8) Set the engine speed.
After starting the engine, move the throttle lever to the 'FAST' position for self-
priming, and check the pump output. Pump output is controlled by adjusting
engine speed, moving the throttle lever in the FAST direction will increase
pump output, and moving the throttle lever in the slow direction will decrease
pump output.
7. STOPPING THE ENGINE
To stop the engine in an emergency, simply turn the engine switch to the 'OFF'
position.
Under normal conditions, use the following procedure:
1) Move the throttle lever to the 'SLOW' position.
RUN
Slow
RUN or OPEN
RUN or OPEN
SLOW
Summary of Contents for 1 inch
