9
NOTE
Attach a sufficiently long and strong rope to the handle before first use.
The pump is submerged into the liquid by using the rope.
In case of continuous use of the pump with the rope, the condition of the rope must
be checked regularly.
NOTE
DO NOT
allow the pump to run dry.
NOTE
The pump must be checked for damage before operation.
The liquid being pumped will become contaminated if this pump becomes damaged and
lubricant within the pump escapes.
MAXIMUM SOLIDS DIAMETER: 35mm
3.0
Screw the elbow into the outlet on the pump body.
3.1
Connect the required diameter pump outlet hose adapter.
3.2
Connect the hose (not supplied) to the pump outlet adapter.
NOTE
: Reducing the hose diameter will affect the maximum flow rate.
3.3
Adjust the depth of the float switch to the desired depth by clipping the float switch
cable into the float switch depth clip at the desired level.
3.4
Insert the pump into the liquid at a 45° angle to help remove as much air as possible.
3.5
If there is any debris or sediment in the liquid, the pump should be placed vertically
on a platform, bricks or similar.
3.6
You must place the pump so there is adequate space for the float switch to operate
without obstruction.
3.7
Always raise or lower the pump using a suitable rope attached to the carrying handle
and not by the mains or float switch cable.
3.8
Connect the pump to the mains.
Always use a high sensitivity Residual Current Device (RCD) with a tripping current
of less than 30mA.
3.9
Turn the mains supply on.
3. OPERATING INSTRUCTIONS
ASSEMBLY
SETTING UP THE PUMP
USING THE PUMP
Summary of Contents for HYSP850D
Page 1: ...1...
