Maintenance
34
www.hyundaipowerproducts.co.uk
01646 687 880
Troubleshooting
The Blade
WARNING
• Never touch a rotating blade.
• Check the blade in order to get a good cut. The blade should always be sharp and well
balanced. At regular intervals, check the tightness of all nuts, bolts and screws.
• If the blade hits an obstacle, check for damage and if the machine vibrates badly, stop the
machine and take it to a service dealer.
• It is best if all interventions on the blade are done at a specialised centre that has the special
tools and equipment.
!
For faults not listed in this table, or which you cannot resolve by yourself, please
contact our aftersales team. Where necessary, all corrective actions should be carried
out by suitably qualified persons.
!
Motor does not start.
Not connected to power
supply.
Power cord or plug is
defective.
Other electrical defect to the
product.
Lock-off button not pressed.
Connect to power supply.
Contact an authorised
service agent.
Contact an authorised
service agent.
Press lock-off button first,
then the start/stop lever.
Product does not reach full
power.
Extension cord not suitable for
operation with this product.
Power source (e.g. generator)
has too low voltage.
Air vents are blocked.
Use a proper extension
cord.
Connect to another power
source.
Clean the air vents.
1
2
3
4
1
2
3
4
1
2
3
1
2
3