- 14 -
ADDING A FUEL STABILIZER TO EXTEND FUEL STORAGE LIFE
When adding a fuel stabilizer, fill the fuel
tank fresh gasoline.
1. Add fuel stabilizer following the
manufacturer's instructions.
2. After adding a fuel stabilizer, run the
water pump outdoors for 10 minutes to be
sure that treated gasoline has replace the
untreated gasoline in the carburetor.
3. Stop the engine, and move the fuel valve
to the
OFF
position.
DRAINING THE FUEL AND CARBURETOR
1. Place an approved gasoline container
below the carburetor, and use a funnel to
avoid spilling fuel.
2. Remove the carburetor drain bolt and
sediment cup, then move the fuel valve
lever to the ON position.
ENGINE OIL
1. Change the engine oil.
2. Remove the spark plugs.
3. Pour a tablespoon (5~10cc) of clean engine oil into the cylinder.
4. Pull the starter rope several times to distribute the oil in the cylinder.
5. Reinstall the spark plug.
6. Pull the starter rope slowly until resistance is felt. This will close the valves so
moisture cannot enter the engine cylinder. Return the starter rope gently.
Storage Precautions
Select a well ventilated storage area away from any appliance that operates with a
flame, such as a furnace, water heater, or clothes dryer.
