Hyundai power products HNHP2500SP-195i, Original Instructions Manual

Page: 15 / 22

15
at low pressure.
The combination of the action of the chemical agents and rinsing with high pressure is very
effective in removing dirt. On vertical surfaces, apply the detergent starting from the bottom
moving upwards. This will prevent the detergent flowing downwards and forming trails.
Similarly, you need to rinse the surface from the bottom upwards.
To remove particularly stubborn dirt, using a brush in a combination with a detergent and a
high-pressure rinse may be necessary.
The next cleaning procedure will help you to better organize your cleaning and obtain optimal
results in minimum time:
A. Before starting, prepare the surface to be cleaned; remove furniture from the working
area and ensure windows and doors are properly closed. Protect or remove any
hazardous materials and any object that may be damaged.
B. Then spray the surface to be cleaned with the high-pressure water jet to remove dirt on
the surface. Before you press the trigger adjust the nozzle for a cone jet and slowly
adjust the shape of the jet until you get the desired result. Thus, you avoid spraying the
surface with a jet that could be too powerful and could cause damage.
C. Start the final rinse from the bottom of the surface moving upwards. Make sure rinsing
the surface so that not even the slightest trace of detergent remains.
5. CARE AND MAINTENANCE
The machine must be switched off and unplugged before any cleaning, maintenance and
replacement of parts. Perform maintenance on this machine regularly according to these
instructions to keep it in good working condition and extend its life.
Always check the high-pressure hose and connectors regularly to ensure there aren't any
damage or issues, as these are essential elements for the machine. Do not use them if they
are damaged.
After each use, perform the following actions:
- Check the cap to verify that it's not blocked by dirt. If necessary, clean the tip and then
rinse it with cold water.
-
Remove the water inlet screen and make sure it is not obstructed. If it is dirty, wipe and
rinse it. When you remove the filter, always put it back in place after cleaning.
- Wash the hoses, connectors and accessories.
-
Clean each time the detergent sprayer and sprays.
- Verify that the air vents are not blocked. Clean the vents if they are dirty.
Other maintenance services:
-
Grease regularly the fittings so that the joints do not dry up.
-
Bring your machine one or twice a year to a qualified technical service for a general
inspection of your device.
NOTE: If repairs need to be made, they should only be performed by personnel
belonging to an approved technical center or qualified technicians.
6. STORAGE
Proceed to its cleaning and remove the hoses and accessories before storage. Check that
there isn't any water in the pipes.
Store the machine, hoses and accessories together in a safe and dry, protected from
moisture and frost.
The machine should be stored in order to be out of the reach of children.
You can install the accessories (multiple jet, turbo nozzle and jet cleaner) behind the machine.