Hyundai power products HNHP2500SP-195i, Original Instructions Manual

Page: 13 / 22

13
3. INSTALLATION AND CONNECTIONS
Connecting pipes
Note: The inlet filter must always be installed to filter out sand, limestone and other
impurities as these may damage the valves of the pump.
- Install the high-pressure hose to the trigger gun and screw it in place (5, 7).
- Connect the machine to the water supply (2, 3 a n d 4). The minimum length
recommended for the water supply pipe is 10 meters (but not exceeding 25 meters) with
a diameter of 12.5 mm to avoid counter-pressures and the risk of potential damage
to your device. Make sure that it can withstand the water and a maximum pressure of
10 bar (0.1 Mpa). If you want to connect your device to other water sources, make
sure that the maximum water input pressure is 10 bar (0.1 Mpa).
- Connect and screw the high pressure hose to the water outlet (6) of the machine.
- Plug the tool to the electrical supply (8).
Install the lance on the gun
- Install the lance on the gun and screw it in place.
Adjusting the nozzle
- High pressure
Trigger must be released; water must not come out of nozzle.
Turn the nozzle counter clockwise. Press the trigger, the
water comes out at high pressure.
-
Low pressure
Trigger must be released; water must not come out of nozzle.
Turn the nozzle clockwise. Press the trigger, the water comes
out at low pressure.