Press “RESET” button, all settings go back to default settings.
Reset function
RESET
Permanent ON/OFF function
Sensor mode
Press “Auto Mode” button, the sensor starts to function and all settings remain the same as the latest status before the light is
switched on/off.
Press the “ON/OFF” button, the light goes to permanent on or permanent off mode, and the sensor is disabled.
* Press “Auto Mode”, “RESET” or “Scene mode” buttons to quit this mode.
The mode will change to AUTO Mode after power failure.
ON/
OFF
Auto Mode
By connecting the “EXT” terminals in parallel (maximum 10pcs, see wiring diagram), no matter which sensor detects motion, all
HEC7030 in the group will turn on the lights when surrounding natural light is below daylight threshold. The detection area is greatly
enlarged in this way. Other settings such as hold-time, stand-by period, stand-by dimming level and daylight threshold on each
individual unit stay the same.
Note: if the surrounding natural light of the sensor which detects movement is sufficient, all lights in the group will not be triggered on.
Master/Slave Group Control
3
Semi-auto Mode (Absence Detection)
4
In many other cases, people do not want to have a sensor to switch on the light automatically, for example, when people is just
passing by, there is no need to have the light on.
Manual Override
5
* Short Push (<1s): on/off function;
On
→
Off: the light turns off immediately and cannot be triggered ON by motion until the expiration of pre-set hold-time. After this
period, the sensor goes back to normal sensor mode.
Off
→
On: the light turns on and goes to sensor mode, no matter if ambient Lux level exceeds the daylight threshold or not.
* Long Push (>1s): adjust the hold-time brightness level.
Note: 1. if end-user do not want this manual override function, just leave the “push” terminal unconnected to any wire.
2. if the detection area is set at “Sensor OFF”, HEC7030 becomes a regular dimmable LED driver which can be dimmed (1% ~ 100%) by push-switch.
3. end-user can choose either function or function for application. Default function is manual override.
This sensor reserves the access of manual override function for end-user to switch on/off, or adjust the brightness by push-switch,
which makes the product more user-friendly and offers more options to fit some extra-ordinary demands:
4
5
Settings (Remote Control HRC-05)
The light turns on full, and
the sensor stays in sensor
mode.
Light does not switch on
when presence detected.
The solution is to apply ‘Semi-auto mode
(absence detection)’: by pressing the “M/A”
button on the remote control and manual
initiation on the push-switch, the motion sensor
remains active, turns on and dims the light
automatically, and eventually switches it off in
absence.
This is a good combination of sensor automation
and maunal override control, to have the
maximum energy saving, and at the same time,
to keep efficient and comfortable lighting.
Short push to activate
the sensor and switch
on the light.
Subject to change without notice.
Edition: 26 Feb. 2020 Ver. A0 Page 4/8
