Subject to change without notice.
Edition: 26 Feb. 2020 Ver. A0 Page 5/6
PIR
HF
PIR tangential movement 10m
HF walking across 8m
3m
PIR
HF
B
PIR
HF
A
3m
4m
PIR tangential movement 10m
HF walking across 8m
3m
PIR tangential movement 10m
HF walking across 8m
Detection Pattern
A rotary switch is built inside the sensor for scene
selection / fast programming. Total 16 channels
are available:
Rotary switch preset
Rotary Switch Preset
Note: settings can also be changed by remote control
HRC-11. The last action controls.
0
5s
100%
Disable
1
1min
100%
50Lux
2
5min
100%
50Lux
3
5min
100%
75Lux
4
5min
100%
100Lux
5
5min
100%
200Lux
6
10min
100%
50Lux
7
10min
100%
75Lux
8
10min
100%
100Lux
9
10min
100%
200Lux
A
20min
100%
100Lux
B
20min
100%
200Lux
C
30min
100%
100Lux
D
30min
100%
200Lux
E
30min
100%
400Lux
F
5s
100%
10%
10%
10%
10%
10%
30%
10%
10%
10%
30%
10%
30%
10%
30%
50%
10%
100Lux
10s
5min
10min
+∞
+∞
+∞
30min
+∞
+∞
+∞
1h
+∞
+∞
+∞
+∞
10s
Detection
range
Channel
Hold-time
Stand-by
time
Stand-by
dim level
Daylight
sensor
Stand-by dimming level
Stand-by time (corridor function)
Press buttons in zone “stand-by time” to set the stand-by period at 0s / 10s / 1min / 5min / 10min / 30min / 1h / +∞.
Note: “0s” means on/off control; “+∞” means bi-level control, the fixture is 100% on when there is motion detected, and remains at the stand-by dimming level
when no presence after motion hold-time.
Press the button in zone “stand-by dimming level” to set the stand-by dimming level at 10% / 20% / 30% / 50%.
Dual tech & RF mode
1. Press buttons in this zone to select sensor technology.
HF+PIR: the light is on when both HF and PIR sensors are activated.
HF/PIR: the light is on when HF or PIR sensors are activated.
2. Learn / Erase, Transmit, RX100% and RX STBY% are disabled.
Daylight harvest auto-configuration function
1. Press button “Shift”, the red LED starts to flash.
2. Select a time period and the sensor will do light level measurement and determine/save the lowest light level (commission line)
with 100% light on, so as to set the target lux level automatically.
Note: 1. Make sure the light level measurement covers the night time.
2. The fixture will go into sensor mode after the measurement, all
sensor settings remain unchanged.
