Mains voltage
Mains current
Power factor
Operation temperature
Dimming interface
Abnormal protection
Dimming range
Stand-by power consumption
Over-heat protection
EMC standard
Safety standard
DALI standard
Dielectric strength
IP grade
220~240VAC 50/60Hz
Output voltage ( U-out max.)
200V
Ta: -20~+50
℃
Tc:+80
℃
Output short-circuit protection with auto-reset
1~30% PWM dimming; 30~100% analogue dimming.
<0.5W
Over-heat protection with auto-reset
EN55015, EN61547, EN61000-3-2/3
EN61347-1, EN61347-2-13, EN60598-1
IEC62386-101,102,207
Input
ĺ
output : 3750VAC
IP20
0.3 ~ 0.25A
34W / 225mA / 36 ~ 150V
38W / 250mA / 36 ~ 150V
41W /275mA / 36 ~ 150V
45W / 300mA / 36 ~ 150V
49W / 325mA / 36 ~ 150V
50W / 350mA / 36 ~ 140V
50W / 375mA / 36 ~ 130V
50W / 400mA / 36 ~ 125V
50W / 425mA / 36 ~ 115V
50W / 450mA / 36 ~ 110V
50W / 475mA / 36 ~ 105V
50W / 500mA / 36 ~ 100V
50W / 525mA / 36 ~ 95V
50W / 600mA / 36 ~ 83V
50W / 550mA / 36 ~ 90V
50W / 575mA / 36 ~ 86V
89%
DALI, Switch-Dim., 1-10V
Max. output
power/current/voltage
Max. Efficiency
SECTION 4 SPECIFICATION
Step2
The commander unit (master unit)
The beeper beeps one time
Beeper beeps rapidly
when RF signal is received
Short press “Transmit” button on RC, the commander unit (master unit) will
beep one time to send the transmission signal.
Upon receiving the transmission signal, the receiver unit (slave unit) will
rapidly beep 3 times in 1s to indicate the success of pairing. Repeat this step
to pair more units. One more short press on “Learn/Erase” button to the
UHFHLYHUXQLWWRFRPSOHWHWKHSDLULQJSURFHVVWKHUHFHLYHUXQLWZLOOTXLWWKH
pairing mode.
Note:
Press button RX100%, the light on receiver unit is 100% on upon receiving
RF on signal; Press “RX STBY%” button, the light(s) goes to preset stand-by
dimming level directly.
The receiver unit (slave unit)
Short press “Learn/Erase” button on RC to activate pairing mode, and the
receiver unit will beep once every second for 3min.
Note: the unit can only pair up to 30 units.
Step1
The receiver unit (slave unit)
Beeper is on for 3min
Short press “Learn
/Erase” button
RF grouping
Short press “Transmit”
button
Step
3
The receiver unit (slave unit)
Beeper is on
Erase:
Long press “Learn/Erase” button for 3s to the sensor unit. The beeper rapidly
beeps for about 5s. all commands it has received before will be erased.
Short press “Transmit”
button
1. HF, PIR, HF+PIR, HF/PIR are disabled.
2. For RF grouping, please see next page.
Dual tech & RF mode [ zone ]
14
