Subject to change without notice.
Edition: 26 Feb. 2020 Ver. A0 Page 4/7
A rotary switch is built inside the sensor for scene
selection / fast programming. Total 16 channels
are available:
Rotary switch preset
Rotary Switch Preset
Note: settings can also be changed by remote control
HRC-11. The last action controls.
0
5s
100%
Disable
1
1min
100%
2Lux
2
5min
100%
10Lux
3
5min
100%
30Lux
4
5min
100%
10Lux
5
5min
100%
30Lux
6
5min
100%
Disable
7
10min
100%
2Lux
8
10min
100%
10Lux
9
10min
100%
30Lux
A
10min
100%
Disable
B
10min
75%
30Lux
C
10min
50%
10Lux
D
30min
100%
50Lux
E
30min
100%
Disable
F
5s
100%
10%
10%
10%
10%
Disable
10%
30%
10%
10%
10%
30%
10%
10%
10%
30%
10%
2Lux
10s
5min
10min
30min
0s
+∞
+∞
10min
30min
+∞
+∞
+∞
+∞
+∞
+∞
10s
Detection
range
Channel
Hold-time
Stand-by
time
Stand-by
dim level
Daylight
sensor
Press the buttons to select light output at 80% (at initial 10,000 hours) or 100%.
Note: “Sensor off” and “Twilight” functions are disabled.
Settings (Remote Control HRC-11)
Press button “RESET”, all settings go back to rotary switch settings.
Reset Settings
Permanent ON/OFF function
Press button “ON/OFF” to select permanent ON or permanent OFF mode.
* Press button “AUTO”, “RESET” to quit this mode.
The mode will change to AUTO Mode after power failure.
AUTO mode
Press button “AUTO” to initiate automatic mode. The sensor starts working and all
settings remain as before the light is switched ON/OFF.
Note: “Semi-auto” function is disabled.
ON/
OFF
Power output
Press the buttons to adjust the light brightness during hold-time.
Load Indication:
The light will flash ONCE rapidly after
receiving the commamd from the
remote control successfully.
Brig/-
& A
4
4h
h
h
HRC-11
Press button “Shift”, the LED on the top left corner is on to indicate mode selection.
All values / settings in RED are valid for 20 seconds.
Shift Button
