Hytera PD782iG, Manual

Page: 8 / 17

3
Charge the Radio
(with battery attached)
Charge the Battery
Before Use
Charging the Battery
Caution:
●
Make sure the radio is powered off
before charging. Read the Safety
Information Booklet in advance to get
necessary safety information.
●
To achieve optimal battery performance,
please charge the battery for at least 5
hours before initial use.
Please use the charger speci fi ed by the Company to
charge the battery. Charging Diagram is listed below.
Charging Status Indication (on charger):
LED Indication Charging Status
The LED Indicator fl ashes red
slowly.
Standby (no load)
The LED Indicator glows red. Charging
The LED Indicator glows
orange.
90% charged
The LED Indicator glows green. Fully charged
The LED Indicator
fl ashes red
rapidly.
Charging failed
Attaching the Battery
Note: To remove the battery, turn off the
radio first. Then slide the battery latch
upwards to unlock the battery and remove
it.
Checking the Battery Power
You may check the current battery power by holding
down the programmed Battery Power Indicator key
preset by your dealer. And release the key to exit.
Battery power indications are listed below:
LED Indication Icon Battery Power
The LED Indicator
glows green.
High
The LED Indicator
glows orange.
Medium
The LED Indicator
glows red.
Low
The LED Indicator
g l o w s r e d a n d
low battery alert
beeps.
U n d e r t h e l o w
battery threshold.
Please recharge or
replace the battery
for proper radio
operation
Attaching the Antenna
Caution: Do not hold the radio by its
antenna, otherwise the performance and
lifespan of the antenna will be reduced.
Attaching the Belt Clip
1. Loosen the screws from the back of the radio.
2. Align the screw holes of the belt clip with those on
the radio’s back, and then tighten the screws.
Attaching the Accessories
1. Open the accessory connector cover as shown
below.