Hytera E-center, User Manual

Page: 22 / 22

is the trademark or registered trademark of Hytera Communications Corporation Limited.
2019 Hytera Communications Corporation Limited. All Rights Reserved.
FCC Statement
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of FCC Rules. These limits
are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates and
can radiate radio frequency energy. If not installed and used in
accordance with the instructions, it may cause harmful interference to
radio communications. However, there is no guarantee that interference
will not occur in a particular installation. Verification of harmful
interference by this equipment to radio or television reception can be
determined by turning it off and then on. The user is encouraged to try
to correct the interference by one or more of the following measures:
z
Reorient or relocate the receiving antenna. Increase
the separation
between the equipment and receiver.
z
Connect the equipment into an outlet on a different
circuit to
that of the receiver's outlet.
z
Consult the dealer or an experienced radio/TV
technician for help.
Operation is subject to the following two conditions:
z
This device may not cause harmful interference.
z
This device must accept any interference received,
including interference that may cause undesired operation.
Note: Any changes or modifications to this unit not
expressly
approved by the party responsible for compliance could void the
user's authority to operate the equipment.
FCC Radiation Exposure St Statement
This equipment complies with FCC radiation exposure limits
set forth for an
un controlled environment .
This transmitter must not be co
‐
located or operating in
conjunction with any other anten na or transmitter. This
equipment should be installed and operated with minimum
distance
2 0cm between the radiator& your body.
ISEDC Radiation Exposure Statement:
This device must be restricted to work related
operations in an
uncontrolled RF exposure
Environment.
This equipment should be installed and operated with
minimum distance
2 0cm between the antenna & your
body.
ISEDC exposition aux radiations:
Ce dispositif doit être limité aux opérations liées au
travail dans un environnement d'exposition RF
professionnel/
un
contrôlé. Cet équipement doit être
installé et utilisé avec un minimum de 2 0cm de distance
entre le antenne et votre.corps.
RF Exposure Compliance and Control
Guidelines and Operating Instructions
To control your exposure and ensure compliance with the
un
controlled environmental exposure limits, always adhere to
the following procedures.
Guidelines
:

Do not remove the RF Exposure Label from the device.

User awareness instructions should accompany device when
transferred to other users.

Do not use this device if the operational requirements
described herein are not met.
Operating Instructions:

Use of non-approved antennas, batteries, and accessories
causes the radio to exceed the FCC RF exposure
guidelines.

Contact your local dealer for the optional accessories of
the product.
Le présent appareil est conforme aux CNR d'Industrie Canada
applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes: (1)
l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur
de l'appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d'en compromettre le
fonctionnement
ISEDC Statement
This device complies with Innovation, Science and Economic
Development Canada Compliance
license-exempt RSS standard(s). Operation is subject to the
following two conditions:

This device may not cause harmful interference.

This device must accept any interference received,
including interference that may cause undesired
operation.