Environmental conditions
Operation
Temperature range
(normal)
+5 °C to +45 °C (+41 °F to
+113 °F)
Temperature range
(extreme, as per
EN 300 394-1)
-30 °C to +55 °C (-22 °F to
+131 °F)
Relative humidity
5 % to 85 % (non-con-
densing)
Degree of protection
IP20
Altitude for operation (max.
altitude of site)
max. 3000 m (9842 ft)
Transport
(in original packaging)
Temperature range
-40 °C to +70 °C (-40 °F to
+158 °F)
Storage
(in original packaging)
Temperature range
-40 °C to +70 °C (-40 °F to
+158 °F)
4.2 Switching on the DIB-R5 flexibleTx
The product is switched on via an on/off switch on the connection and control panel. After
switching on the DIB-R5 flexibleTx, the integrated hardware components will automati-
cally start up. Connections will be enabled. All the components are started up after
approx. three to five minutes.
To switch on the product, the connections must have been made properly and the power
source at the installation site must have been switched on already. The procedure for
switching on the power source depends on the circumstances at the respective installa-
tion site.
Several on/off switches with redundant power supply lines
With redundant power supply lines (optional), the DIB-R5 flexibleTx features two on/off
switches and two separate power sources, if necessary. Each of them has to be
switched on for commissioning the product.
Switching on the DIB-R5 flexibleTx
Preparation:
n
The DIB-R5 flexibleTx must be connected with the grounding system of the power
source at the installation site.
n
All required connecting cables as well as antennas must be connected.
n
The alarm contacts must be wired.
1.
Switch on the power source via the corresponding equipment at the installation site.
ð
The integrated hardware components start up.
Operation
Switching on the DIB-R5 flexibleTx
DIB-R5 flexibleTx
64
Operation Manual 90DIBR5flexibleTxOM02 - 1.2
