●
Monitor Momentary
Long press the preprogrammed Monitor Momentary key to open the signalling
squelch; release the key to exit.
●
Squelch Off
Press the preprogrammed Squelch Off key to open the noise squelch; press the key
again to exit.
y
ss the preprogrammed Squelch Off Momentary key to open the noise squelch;
k / Adjust Squelch Level
curr
preprogrammed Adjust Squelch Level key to adjust the squelch level.
leve
d the adjusted level is saved.
Pre
Scan key, scan starts from the current channel and ascends
rough the channel numbers in scan list. Green LED flashes in scan mode and solidly
lling matches. Press the Scan key
annel Temporary Delete
eleted.
■
You cannot delete a channel if there will be less than 2 channels available for
scanning.
●
Squelch Off Momentar
Long pre
release the key to exit.
Squelch Level Chec
Long press the preprogrammed Squelch Level Check key to hear the squelch level of the
ent channel.
Short press the
Each time when you press the key, a Beep tone sounds, squelch will be increased by one
l (0
～
9
～
0) an
Scan
ss the preprogrammed
th
glows when a signal is received on a channel and signa
again to exit from scan mode.
●
Nuisance Ch
When scanning stops on a channel, press the preprogrammed Nuisance Channel
Temporary Delete key to temporarily remove that channel from the scan list.
■
A priority channel can’t be permanently d
■
To restore the deleted channel back to the scan list, simply exit from scan mode
or switch the radio off and back on.
21
