TC-600 Service Manual
7
●
Short out the two SELF points.
●
Turn on the power and rotate the Channel Selector Knob to CH7.
●
Press PTT while holding down Function Key.
●
After reset, turn off the power and disconnect the two SELF points. The radio operates at the
preset frequency after restart.
Note
: Once the new model is set, previous channel settings (frequency, CTCSS/CDCSS, channel
function settings) will be deleted, and part of functions are also changed. Therefore, do not make this
operation unless it’
s necessary, such as changing the EEPROM, etc.
3. PC Programming Mode
The following parameters can be set through the programming software:
(1)
Receive frequency and transmit frequency
(2)
Receive signaling and transmit signaling
(3)
Busy channel lockout (BCL)
(4)
Time-out timer (TOT)
(5)
Squelch level
(6)
Battery save
(7)
Audio alarm
(8)
Monitor mode
(9)
Scan mode
(10) Scan revert channel
(11) Priority scan channel
(12) Wideband/narrowband per radio
(13) High/low power
(14) Wideband/narrowband per channel
4. PC Adjust Mode
The following settings can be adjusted through the programming software:
(1)
Low battery alert level
(2)
SQL9
(3)
SQL3
(4)
CTCSS deviation (wide)
(5)
CDCSS deviation (wide)
(6)
CTCSS deviation (narrow)
(7)
CDCSS deviation (narrow)
