TC-600 Service Manual
6
Radio Modes
Mode
Entry for Mode Startup
Audible & Visual Indicator
User Mode
Disconnect the SELF points and then turn the
power on
Power-on alert tone (one long Beep)
Model Set Mode
Short out the SELF points and then turn the power
on
2 short Beeps, the light flashes from red
to green
User Wired Clone Mode
Disconnect the SELF points, turn on the power
while holding down Function Key, press Function
Key again
1 short Beep
Factory Wired Clone
Mode
Short out the SELF points, turn on the power while
holding down Function Key, press Function Key
again
2 short Beeps
Manual Adjust Mode
Enable Manual Adjust Mode, turn on the power
while holding down PTT and Function Key
simultaneously, the radio enters this mode in 2
seconds
2 short Beeps, orange light glows
PC Programming &
Adjust Mode
Connect the radio with PC, turn on the radio and
activate this mode in programming software
1. User Mode
User Mode is for conventional communication operation. Disconnect the two SELF points and then
turn the power on, the radio enters User Mode. (Refer to “TC-600 Owner’
s Manual” for detailed
operation description.)
2. Model Set Mode
(1)
Select MS1 according to the radio model. If MS1 is 1, short out the two MS1 points on PCB. If
not, disconnect the two MS1 points.
(2)
Short out the two SELF points and then turn the power on. Two Beeps sound.
(3)
Turn Channel Selector Knob to the corresponding position (1-11) according to the radio model
(Refer to “
Initial Data Table”
).
(4)
Press PTT while holding down Function Key to set the model. Channel data and settings are
initialized (Refer to “Initial Data Table”).
(5)
Turn off the power and then disconnect the two SELF points to complete the model setting.
For example, MS1 of TC-600U (450.000~469.995MHz) is 0 and its model is 7(Refer to “
Initial
Data Table”
). To initialize its model and channel data, you can operate as following:
●
Disconnect the two MS1 points.
