600 SRM 496
Distributor Repair
WARNING
DO NOT remove the radiator cap from the ra-
diator when the engine is hot. When the radi-
ator cap is removed, the pressure is released
from the system. If the system is hot, the steam
and boiling coolant can cause burns. DO NOT
remove the cover for the radiator when the en-
gine is running.
11. After engine has been operated, stop engine. If
coolant is hot, give engine time to cool. Check
coolant level and add coolant if necessary.
1.
TENSIONER
2.
SPRING
3.
LOCK BOLT
4.
TENSION SIDE
Figure 47. Timing Belt Installation
Distributor Repair
NOTE: This section only has the removal and instal-
lation procedures for the distributor. Service proce-
dures for the ignition system are found in the Elec-
trical System section.
REMOVE
1.
Rotate crankshaft until No. 1 piston is at TDC
on compression stroke. Make note of position of
distributor rotor. See Figure 48.
2.
Disconnect wires at spark plugs.
3.
Remove capscrew from flange of distributor shaft
housing. Lift distributor assembly from engine.
INSTALL
1.
Rotate crankshaft until No. 1 piston is at TDC on
compression stroke. Put rotor in correct position.
See Figure 48.
2.
Lubricate O-ring and gear on distributor engine
oil.
Install distributor, making sure to align
marks on distributor housing, distributor gear,
and engine.
3.
Connect wires at spark plugs.
Figure 48. Distributor Replacement
21
