1. DRAIN PLUG
2. O-RING
3. FUEL/WATER SEPARATOR SENSOR
4. FUEL LIFTER ELEMENT BODY
5. FUEL FILTER
6. FUEL FILTER COVER
Figure 25. Fuel/Water Separator Sensor
Install
1.
Install new sensor into bottom of fuel filter ele-
ment body. See Figure 25.
2.
Connect sensor to wire harness.
3.
Install new O-ring onto drain plug. Install
drain plug into bottom of fuel/water separator
sensor. See Figure 25.
4.
Connect battery and close hood.
Glow Plug Relay
Remove
WARNING
Always disconnect the cables at the battery be-
fore you make repairs to the engine. Disconnect
the cable at the negative terminal first. Install a
tag on the battery terminals so that no one con-
nect the cables on the terminals.
1.
Open hood and disconnect battery.
2.
Tag and disconnect wiring connectors at termi-
nals E and S. See Figure 26.
3.
Slide protective boots back on wires fro termi-
nals B and M. See Figure 26 and Figure 27.
4.
Place tags on wires for terminals B and M to
properly identify them for reinstallation.
5.
Remove nuts, washers, and wires from Termi-
nals B and M. See Figure 27.
6.
Remove nuts and glow plug relay from mount-
ing bracket. See Figure 28.
2200 SRM 1771
Sensors and Switches
23
