8000 SRM 1009
Recommended Schedule of Maintenance
ELECTRICAL SYSTEM CHECKS
NOTE: DO NOT use Steam to Clean Electrical Parts
A - Every 8 Hours
B - Every 350 Hours
C - Every 2000 Hours
X - Indicates Visual Inspection, Repair, or
Replace as Required
O - Indicates Drain and Fill
Component:
A
B
C
Clean all Controls
X
Interlock Switches - Functioning
X
All Motors - Clean with Compressed Air - Functioning
X
All Motors - Clean Power Wire Terminals - Functioning
X
Battery Box and Connectors - Neutralize and Clean
X
Battery Condition - Physical and Electrical
X
X
All Wire Connections - Tightness and Corrosion
X
Contactors - Tips and Wire Connections - Tightness and Corrosion
X
NOTES:
1. Tires - Condition affects stability, safety, and load capacity that can be handled safely.
2. Under Normal Conditions, it is recommended that the Load Wheel Bearings be lubricated every 200
hours, minimum. The load wheel bearings are cleaned and repacked every 2000 hours. For trucks equipped
with the Food Processing Package or operate under Wet or Corrosive Conditions, it is recommended
to lubricate the lift linkage every 50 hours. Load wheel bearings should be inspected every 350 hours.
3. See Capacities and Specifications 8000 SRM 1010 for all lubrication specifications.
4. The presence of hydraulic fluid on cylinder rods and fittings does not necessarily indicate a leak.
5.
Recycle all waste oils.
GENERAL CHECKS
A - Every 8 Hours
B - Every 350 Hours
C - Every 2000 Hours
X - Indicates Visual Inspection, Repair, or
Replace as Required
O - Indicates Drain and Fill
Component:
A
B
C
All Bolts, Nuts, Cotter Pins, Etc.
X
NOTES:
1. Tires - Condition affects stability, safety, and load capacity that can be handled safely.
2. Under Normal Conditions, it is recommended that the Load Wheel Bearings be lubricated every 200
hours, minimum. The load wheel bearings are cleaned and repacked every 2000 hours. For trucks equipped
with the Food Processing Package or operate under Wet or Corrosive Conditions, it is recommended
to lubricate the lift linkage every 50 hours. Load wheel bearings should be inspected every 350 hours.
3. See Capacities and Specifications 8000 SRM 1010 for all lubrication specifications.
4. The presence of hydraulic fluid on cylinder rods and fittings does not necessarily indicate a leak.
5.
Recycle all waste oils.
15
Summary of Contents for B218
