ZAPI™ HANDSET
NOTE:
The ZAPI handset will display the code:
V1.07 (or a higher number) for 1 to 2 seconds every
time the key switch is turned to the ON position.
This code represents the EEPROM software ver-
sion and DOES NOT INDICATE A FAULT CODE.
The ZAPI™ handset must be connected to the con-
troller before turning on the key. The handset must
have an adapter harness to connect to the control-
ler. The handset and adapter harness are available
from your Hyster dealer. Connect the handset to
plug D. The handset can remain connected to the
controller while running, and the parameters can
be changed in real time. In this case, it is necessary
to go in a standby condition (truck at rest) before
switching OFF the controller in order to store the
new values in the EEPROM.
This section describes the ZAPI™ handset func-
tions. Six buttons provide the capability of chang-
ing or reading the parameters.
NOTE:
After a modification, save the new values
by pushing out, then enter to confirm. (Screen
prompts will guide the user.)
To navigate the menu options, numbers inside the
triangles in the following map correspond to the
same number on the handset keyboard buttons.
The orientation of the triangle indicates the way to
the next function. See Figure 3.
NOTE:
Connect and disconnect the handset only
with the key switch in the OFF position.
For additional handset description, see Figure 4.
1
Roll-Up
Push to scroll up.
2
Roll-Down
Push to scroll down.
3
Enter
Push to enter a
submenu or to confirm a
change.
4
Out
Push to exit a selected
menu or to refuse a
change.
5
Set-Up
Push to increase a
parameter value.
6
Set-Down
Push to decrease a
parameter value.
Programming
2200 SRM 1064
8
