3501 Actuator
INSTALLATION REFERENCE MANUAL
17
MX4754 Rev. B ©2019
www.hysecurity.com • 800-321-9947
11
RUN ACTUATOR CABLE(S) TO CONTROL BOX
Run the cable of the actuator closest to the control box through a hole (with rubber grommet) in the bottom
on the control box.
If a dual gate installation:
1. Dig a trench across the driveway deep enough to accommodate the longer harness cable from the
actuator furthest from the control box.
2. Run the cable through an appropriate conduit and lay this in the trench.
3. Cover the trench and use asphalt patch if needed.
4. Run the 2nd cable into a hole (with rubber grommet) into the bottom of the control box.
NOTE:
Ensure the cable(s) reaches into the control box sufficiently to reach the MOTOR inputs on the
control board.