- 4 -
Introduction
Description
Hypro Piston
pumps are designed for creating and boosting pressure in fluid circuits. The pump operates by taking in fluid
from the inlet port after which it is slung by the piston and expelled through the outlet port. Construction features come in
a variety of materials in order to be resistant to a range of chemicals. Standard models of Piston pumps shaft rotation is
bi-rotational.
Intended Uses
Hypro Piston pumps are intended for creating or boosting dynamic pressure in approved fluids. Hypro Piston pumps
should never be used to pump liquids above 140°F (60°C), or below 34°F (1°C). Any uses outside of those specified in
this manual are considered misuses and are prohibited. Contact Hypro technical service with any questions regarding
specific acceptable uses.
Purpose of Manual
This manual provides instructions and requirements that must be met when installing, using and maintaining the
product(s) identified on the cover.
If the product is sold, the seller must pass this manual onto the new owner.
The following special attention notices are used to notify and advise the user of this product of procedures that may be
dangerous to the user or result in damage to the product.
ATTENTION
Attention is used to notify of installation, operation, or maintenance information that is important but not safety related.
This symbol is used to denote the presence of an electrical hazard that will result in personal injury, death or property
damage.
This symbol is used to denote the presence of a hazard that will result in personal injury, death or property damage.
California Proposition 65 Warning
-- This product and related accessories contain chemicals known to the
State of California to cause cancer, birth defects or other reproductive harm.
Misuses
Hypro Piston pumps are designed to operate effectively within the specified speed, pressure and environmental ranges.
Going outside of these ranges will void the warranty and could cause damage to property or serious injury or death.
• DO NOT
run the pump faster than the maximum specified speed.
• DO NOT
run the pump higher than the maximum specified pressure.
• DO NOT
run pumps when the liquid has exceeded the maximum or minimum temperature limit (see Intended Uses).
• DO NOT
pump non-approved liquids.
• DO NOT
pump water or other liquids for human consumption.
• DO NOT
operate any pump under the influence of drugs or alcohol.
• DO NOT
run the pump dry.
Summary of Contents for 5315C Series
Page 22: ...Notes...
