22
RIOT CONTROL USER MANUAL
PORTS TAB
UART 1
will be used for your serial receiver. Make sure the
Serial
RX
switch is turned ON for
UART 1
.
UART 3
can be used for ESC telemetry when available. To use this,
select the
ESC
option from the
Sensor Input
dropdown for
UART 3
UART 6
will be used for your Video Transmitter Settings (or
RunCam Split, which is not covered in this manual). Select the
correct VTX Protocol from the
Peripherals
dropdown for
UART 6
.
SOFTSERIAL 1
will be used for FrSky Telemetry. Select the
SmartPort
option from the
Telemetry Output
dropdown for
SOFTSERIAL 1
.
If the
SOFTSERIAL 1
port is not available, enable it by following
the instructions on Page 21.
Press
SAVE
before moving to the next tab.
Summary of Contents for Riot Control
Page 1: ...Riot Control F L I G H T C O N T R O L L E R USER MANUAL...
Page 4: ...4 RIOT CONTROL USER MANUAL BOARD LAYOUT...
Page 11: ...11 RIOT CONTROL USER MANUAL FrSky R XSR Wiring Enable Inversion for FrSky...
Page 13: ...13 RIOT CONTROL USER MANUAL SPM 4649T Wiring Disable Inversion for Spektrum Serial...
