WARRANTY
Hypertherm
Plasma Systems
iii
8-06
Warning
Genuine Hypertherm parts are the factory-
recommended replacement parts for your
Hypertherm system. Any damage caused by the
use of other than genuine Hypertherm parts may
not be covered by the Hypertherm warranty.
Warning
You are responsible for the safe use of the
Product. Hypertherm does not and cannot make
any guarantee or warranty regarding the safe use
of the Product in your environment.
General
Hypertherm, Inc. warrants that its Products shall
be free from defects in materials and
workmanship, if Hypertherm is notified of a defect
(i) with respect to the power supply within a period
of two (2) years from the date of its delivery to
you, with the exception of Powermax Series
power supplies, which shall be within a period of
three (3) years from the date of delivery to you,
and (ii) with respect to the torch and leads within a
period of one (1) year from its date of delivery to
you. This warranty shall not apply to any Product
which has been incorrectly installed, modified, or
otherwise damaged. Hypertherm, at its sole
option, shall repair, replace, or adjust, free of
charge, any defective Products covered by
this warranty which shall be returned with
Hypertherm’s prior authorization (which shall not
be unreasonably withheld), properly packed, to
Hypertherm’s place of business in Hanover,
New Hampshire, or to an authorized Hypertherm
repair facility, all costs, insurance and freight
prepaid. Hypertherm shall not be liable for any
repairs, replacement, or adjustments of Products
covered by this warranty, except those made
pursuant to this paragraph or with Hypertherm’s
prior written consent. The warranty above is
exclusive and is in lieu of all other warranties,
express, implied, statutory, or otherwise with
respect to the Products or as to the results
which may be obtained therefrom, and all
implied warranties or conditions of quality or
of merchantability or fitness for a particular
purpose or against infringement. The
foregoing shall constitute the sole and
exclusive remedy for any breach by
Hypertherm of its warranty. Distributors/OEMs
may offer different or additional warranties, but
Distributors/OEMs are not authorized to give any
additional warranty protection to you or make any
representation to you purporting to be binding
upon Hypertherm.
Certification test marks
Certified products are identified by one or more
certification test marks from accredited testing
laboratories. The certification test marks are
located on or near the data plate. Each certification
test mark means that the product and its safety-
critical components conform to the relevant national
safety standards as reviewed by that testing
laboratory. Hypertherm places a certification test
mark on its products only after that product is
manufactured with safety-critical components that
have been authorized by the accredited testing
laboratory.
Once the product has left the Hypertherm factory,
the certification test marks are invalidated if any of
the following occurs:
• The product is significantly modified in a manner
that creates a hazard or non-conformance.
• Safety-critical components are replaced with
unauthorized spare parts.
• Any unauthorized assembly or accessory that
uses or generates a hazardous voltage is added.
• There is any tampering with a safety circuit or
other feature that is designed into the product as
part of the certification.
CE marking constitutes a manufacturer’s
declaration of conformity to applicable European
directives and standards. Only those versions of
Hypertherm products with a CE Marking located on
or near the data plate have been tested for
compliance with the European Low Voltage
Directive and the European EMC Directive.
