M
AINTENANCE
/P
ARTS
5-5
Operator Manual
2. Connect the two red wire from the torch lead to the butt splice connecting the red wire to the pilot
arc fitting using the crimping tool.
3. Connect the two blue wires from the torch lead to the butt splices connecting the white wires to the
microswitch using the crimping tool.
4. Connect the four white wires from the torch lead to the butt splice connecting the black plunger wire
to the torch main body using the crimping tool.
5. Connect the cinch strap (Tyrap) as shown.
6. Install the torch main body assembly and torch switch into one of the handle halves. While position-
ing the handle halves together, be careful not to pinch any wires. Be especially careful around
the torch switch retainers.
7. Replace the five screws to secure the handle halves together. If the seams do not fit together
tightly, remove the screws and check for pinched wires.
2
3
1
4
5
6
Figure 5-2 PAC110 Torch Repair
