MAX200
Instruction Manual
7-1
15
Section 7
WIRING DIAGRAMS
Introduction
This section contains the wiring diagrams for the MAX200 system. When tracing a signal path or referencing with
the Parts List or Troubleshooting sections, please be aware of the following format to assist you in understanding
the wiring diagrams' organization:
•
Sheet numbers are located in the lower right-hand corner.
•
Page-to-page referencing is done in the following manner:
C
SHEET
4-D3
C
SHEET
4-D3
Destination and Source Coordinates refer to letters A-D on the Y-axis of each sheet and numbers 1-4 on the
X-axis of each sheet. Lining up the coordinates will bring you to the source or destination blocks (similar to a road
map).
Wiring Diagram Symbols
Wiring diagram symbols and their identification precede the system wiring diagrams in this section.
Source Connection
Source Reference Block
Destination Sheet #
Destination
Coordinates
Source Sheet #
Source Coordinates
Source Reference Block
Destination
Coordinates
Summary of Contents for MAX200
