Hyperion Gateway Installation Guide
www.wrensolutions.com
7L776
Rev A 190510
A
BOUT
THIS
D
OCUMENT
This document pertains to installation of the Hyperion Gateway (IDS-
CCULD). Before installation, please familiarize yourself with this
installation guide and review the Hyperion User Guide to understand
system configuration and setup. Supporting documentation can be
found in the Wren Support Portal at
www.wrensolutions.com/support.
P
RODUCT
M
ODIFICATIONS
This product is to be installed and used for the specific purpose for
which it was designed. It is not to be modified or serviced by anyone
other then Wren. Unauthorized changes or modifications to the
product will result in the warranty being voided and could possibly
invalidate regulatory certifications.
W
ARRANTY
Unless otherwise noted, all products are covered by Wren's Standard
Limited Manufacturer's Warranty as set forth in the current version of
Wren's
I
NTELLECTUAL
P
ROPERTY
R
IGHTS
Wren maintains certain intellectual property rights that may pertain to
this product. To see a list of our patents, please refer to our
T
RADEMARK
A
CKNOWLEDGMENTS
Wren®. the Wren logo, Hyperion® and the Hyperion logo are
trademarks of Wren. The trademarks that are followed by ® are
registered trademarks in the U.S. All other trademarks and/or
registered trademarks mentioned herein are properties of their
respective owners and are for reference purposes only. The use of
such third party trademarks does not indicate any affiliation with or
sponsorship of or by Wren. All rights reserved.
N
OTICES
RF Exposure for FCC
WARNING
:
To satisfy FCC RF exposure requirements for mobile
transmitting devices, a separation distance of 31 cm or more should be
maintained between the antenna of this device and persons during
device operation. To ensure compliance, operations at closer than this
distance is not recommended. The antenna used for this transmitter
must not be co-located in conjunction with any other antenna or
transmitter.
RF Exposure for IC
WARNING
:
To satisfy IC RF exposure requirements for mobile
transmitting devices, a separation distance of 44 cm or more should be
maintained between the antenna of this device and persons during
device operation. To ensure compliance, operations at closer than this
distance is not recommended. The antenna used for this transmitter
must not be co-located in conjunction with any other antenna or
transmitter.
AVERTISSEMENT
:
Pour satisfaire IC RF exigences d’exposition pour
les appareils mobiles de transmission, une distance de séparation de 44
cm ou plus doit être maintenue entre l’antenne de cet appareil et des
personnes pendant le fonctionnement de l’appareil. Pour assurer la
conformité, les opérations au plus près que cette distance ne sont pas
recommandés. L’antenne utilisée pour cet émetteur ne doit pas être
situé en conjonction avec une autre antenne ou émetteur
.
(800) 881-2249
E
XTENSION
4
P
RODUCT
S
UPPORT
For comprehensive product support including manuals, FAQs and
troubleshooting, visit our customer support portal
WWW
.
WRENSOLUTIONS
.
COM
/
SUPPORT
