EOS LBA 10 – HARNESS WIRING FOR HYPERION A123 PACKS
Hyperion A123 packs use the ‘lipoly’ 6S-type battery-side connector for all packs 2S~6S. The A123 PACK Connector plugs directly into LBA10
without additional harnesses between A123 pack and LBA10. If you are building your own large-capacity lithium polymer packs from loose cells, or
your own packs using A123 cells, we suggest this method below as best practice. (use #HP-EOSLBA-MC-P6-L connector to wire packs)
Note:
Current A123 2300mAh cells have a protruding button which is NEGATIVE polarity. Whenever assembling any pack, be sure of the polarity
before beginning wiring. Future A123 cells could differ from the diagram supplied above, in this respect.
Note:
Current A123 Cells may be safely fast charged at rates up to 10A per cell (or roughly 4C), for charge times in the range of 10 to 15 minutes.
Consult documentation for your pack to be sure about max recommended charge rates.
EOSLBA10-A General Specifications Protection
Voltages
(± 0.01V)
Input Voltage (charger)
55.0 Volts Max *
Over Charge
4.30 V/cell
Lithium Poly/Ion 3.7V nominal type only
Over Discharge
3.05 V/cell
Supported Output
Battery Types
A123-Brand cells 3.3V nominal only
Power Down V
2.90 V/cell
Battery Volt Range
6.0V~26.0V ( 2S~6S LiPo or A123)
3.7V LiPo
Mode
Short Protect
2.00 V/cell
Max Charge Current
10A
Over Charge
3.90 V/cell
Voltage Resolution
±5mV
Over Discharge
2.85 V/cell
Power Down V
2.70 V/cell
3.3V
A123
Mode
Short Protect
2.00 V/cell
For additional technical support, please first contact the Hyperion dealer from whom you purchased the LBA10.
*Note: The LBA10 has been specifically designed to be compatible with the majority of chargers on the market, and tolerant of high transient
voltages. However, some chargers on the market may output extremely high transient voltages when they encounter an open circuit, which could
potentially damage any Balancer or PCM device, regardless of safeguards employed. Therefore, it is “best practice” to use Hyperion chargers, as
they are expressly designed to limit voltage under open-circuit conditions, and are guaranteed safe with any PCM or Balancer device.
Warranty
Hyperion LBA10 are fully guaranteed against defects in material or workmanship for 12 months from date of purchase. The warranty does NOT
cover damage to reverse-polarity connection, over-spec use, water or impact damage, nor any other claim not arising from a defect in materials or
assembly. You must contact your selling dealer with details of the problem before making a return. In most cases, the problem is an
issue with setup, and can easily be resolved at no expense to you. Items returned without notice in which defects are not found can only be
returned to the sender at his expense.
We sincerely hope you enjoy this Hyperion Product!
The Hyperion Team
