use the Hypersphere Mini, or any vibration high-intensity exercise device without first obtaining
approval from your doctor if any of the following apply: Pregnancy, diabetes with complications
such as neuropathy or retinal damage, wear of pace-makers, recent surgery, epilepsy or migraines,
herniated disks, spondylolisthesis, spondylolysis, or spondylosis, recent joint replacements or IUD’s,
metal pins or plates or any concerns about your physical health. Frail individuals and children should
be accompanied by an adult when using any vibration device. These contra indications do not
mean that you are not able to use a vibration or exercise device but we do advise you to consult
a doctor first. Ongoing research is being done to the effects of vibration exercise for specific
medical disorders. This will likely result in the shortening of the list of contra indications as shown
above. Practical experience has shown that integration of vibration exercise into a treatment plan
is advisory in a number of cases. This must be done on the advice of and in accompaniment with a
doctor, specialist or physiotherapist.
OPERATING INSTRUCTIONS
READ ALL INSTRUCTIONS BEFORE USING THE HYPERSPHERE MINI
CHARGING
Fully charge for two hours before first use. To charge, connect the USB cable from the charging port
to any standard USB charger (not included). LED lights illuminate to show battery level and indicate
active charging. LED lights will remain illuminated when fully charged while adapter is plugged in.
Unit may be recharged at any time and at any battery level. It is not recommended to fully deplete
the battery to the red LED level. Recharge the unit monthly to best prolong battery life. The average
run-time is 2 hours at level three, and longer at lower levels.
OPERATING
To turn on, press down on the power button for three seconds until LED lights illuminate. Press
again once for level one, twice for level two and three times for level three. The blue LED lights
will indicate the corresponding power level. Do not use directly on a hard surface. Use only on a
carpeted floor or a fitness mat. To turn off, press down on the power button for three seconds. The
unit is fully turned off when all the LED lights are off. The unit will turn off after 10 minutes of use. To
continue use, turn unit on again and set to desired level.
