HyperFlight
Pulsar 4000e Assembly Guide
Servo installation for Pulsar 4000e
Wing Center Section and Flaps
· I start by adding the aileron and flap servo
wiring. I use twisted wire and solder a servo
socket on the wire at the outer ends of the
panel. The socket is then GLUED in place,
saves you fishing for the end that disappeared
into the wing when you go to assemble the
model on the flying field. My convention is for
the signal wire to be nearest to the wing joiner.
Leave spare wiring in the center section to
connect to a plug latter on.
· Cut a piece of thin ply (1/32 or 1/64) and Cyano
into the bottom of the servo well. (adds a bit of
strength to the balsa plate)
Depending up the servo type used it may be
necessary also to add an additional piece of 2 or
3mm light ply to raise the servo to the right
height. (I used
HS85 MG
and a 2mm piece of lite
ply)
· Before gluing the servo in cut the slot in the
balsa inset in the flap for the horn to be glued into The photos show the horn filled to
shape, and the slot in the flap).
· Glue the horn in place and test the set-up as mentioned above (Servo installation my
method)
· The photo shows the servo glued in place and linkage added, the 2mm lite ply plate
can also be seen in this photo.
(c) 2012 HyperFlight Drybank Farm Fose Way Ettington Stratford-on-Avon Warwickshire CV37 7PD
7
