PRO Stormtrooper / Bounty Hunter Voice Amp,
2005 Hyperdyne Labs
3
SECTION B. – BASIC SETUP AND OPERATION
Microphone setup:
Plug in your microphone and amplified speaker using an 1/8” cable. If you already own a Radio Shack amplified
speaker (#277-1008C or the common black PA speaker), you can use this with your trooper amp. You may have to
dial down the output volume in order to avoid too much feedback. See Section C on how to do this.
If you are using an electret mic that
DOES NOT
have an external battery, you will have to use the shorting terminal
to enable power to the electret mic. See the below pic for details on how to do this. If you have a mic that has an
external battery and on/off switch (similar to Radio Shack #33-3012), you can leave the 2 gold pins on the board
disconnected. By shorting these two gold pins together, you are providing power to the mic. For the optional mic,
you must short the pins together for it to operate.
NOTE: A condenser mic will not work with the board, as the output will be too low for you to hear.
