Hyper Split Hydraulic Log Splitter
ToolTuff Direct LLC, 15000 W44th Ave, Ste B, Golden CO 80403 Page 7
Warning:
After the slotted nut is tightened, turn back ¼ circle to make
sure the wheel can rotate smoothly and freely. Failure to turn the
slotted nut back will cause the wheel damage to wheel bearing.
Step 2: Support Leg to the Tow Bar
Attach the “Y” Stand (#5) to the tow bar (#10) secure using a hex bolt
(#9), flat washer (#8), lock nut (#7), and lock pin (#6).
Step 3: Attach Tow Bar to the Hydraulic Tank
Attach the tow bar (#10) to the hydraulic tank (#38) and secure using
two hex bolt (#37), flat washer (#3), and lock nut (#4).
Step 4: Attach the beam assembly
Attach the beam assembly (#18) to the hydraulic tank (#38) and secure
using the hinge pin (34), flat washer (#36), and cotter pin (#35).
Step 5: Engine Assembly
Place the four isolation mounts (#55) between the mounting plate and
engine.
Position the engine (#53) over the isolation mounts and secures it to the
mount plate put the hex bolt (#54), and flat washer (#24) through the
bottom of the plate. Place a flat washer (#124 and tighten the lock nut
(#28).
Step 6: Attach log table
Attach the log table (#32) to the engine side of beam (#18) and secure
using the hex bolt (#31), flat washer (#8), and lock nut (#7).
Step 7: Attach Hydraulic Hose
Connect hydraulic hose according to the picture below.
