HYLITE MIGHTYLITE PRO – INSTALLATION AND OPERATING INSTRUCTIONS
The Hylite Mightylite Pro floodlight a high-powered, professional LED floodlight which is suitable for use outdoors in a range of
commercial applications including lighting perimeters, car parks, garden areas and outside warehouse facilities.
The unit requires connection to a 230 AC 50Hz mains electricity supply.
1. IMPORTANT SAFETY INSTRUCTIONS
WARNING: THIS PRODUCT MUST BE INSTALLED BY A QUALIFIED ELECTRICIAN, AND CHECKED TO ENSURE
IT IS SAFE, BEFORE USING.
PLEASE FOLLOW THESE INSTRUCTIONS CAREFULLY BEFORE ATTEMPTING TO INSTALL AND OPERATE
THIS LIGHT.
1.1. IMPORTANT INSTALLATION INSTRUCTIONS
The risk of electric shock should be minimized by the installation of appropriate safety devices including the incorporation
of an RCCB (Residual Current Circuit Breaker) into the main distribution board.
DO NOT wire this floodlight into the lighting circuit. Use a switched fused spur. Cables should always be protected against
short circuit and overload by use of an RCD.
Ensure the voltage marked on the product is the same as the electrical power supply to be used.
DO NOT install the light indoor or where it is likely to be knocked or hit; in hot or humid conditions such as near an exhaust
outlet e.g. boiler flue, dryer outlet.
1.2. IMPORTANT OPERATION & MAINTENANCE INSTRUCTIONS
DO NOT position the light near flammable or combustible materials (such as wood, cloth, paper) or near flammable,
combustible or explosive liquids, solids, gases or equipment.
DO NOT direct the light into a person’s eyes. This light has a very intensive light output, which if incorrectly used could
cause eye damage.
ALWAYS disconnect the mains power supply before servicing or performing any maintenance.
ALWAYS maintain the light in good condition, with repairs only undertaken by a qualified electrician.
ONLY carry out repairs using genuine parts. Non-authorized parts may be dangerous and will invalidate the warranty.
1.4. TOOLS REQUIRED
Electric/hand-held drill
No.8 masonry drill bit
Electricians screwdriver
Large cross-head screwdriver
Small cross-head screwdriver
Wire cutters
THIS PRODUCT IS SUITABLE FOR WALL
MOUNTING ONLY
- 2 -
- 3 -
1.3. PARTS INCLUDED
1x Mightylite Power House LED Floodlight with connection
box and cable gland
1 x Allen key
2 x Allen Screws M3 X 10 HE
2 x M8 X 12 Bolts
2 x M8 X 16 Large washer
2 x M8 x 12 Spring Washer
2 x M3 Small Washer
4 x Plastic Screw Cover 6mm
2 x Pipe Bracket Screw 5mm x 20mm
2 x Pipe Bracket Square Nut 5mm
1 x Pipe Bracket 35.5cm Long
1 x U-Bracket 155mm x 320mm x 155mm
