OUTPUT TONE SETTING
Use the DIP switch on the back of the sounder body to select the tone required; for this function the first five switches are used, highlighted in
picture 12.
The switches positioned upwards acquire value
“1”;
on the other hand, if positioned downwards acquire value
“0”.
1)
From the MAIN TONE SET table or the ALTERNATE TONE SET table (the choice of the table depends on how the sounder
’
s wiring has
been carried out) select the output alarm tone triggered when the sounder is activated.
2)
Refer to the corresponding line of the
“
DIP configuration
”
column to select the five switch selection settings.
OUTPUT VOLUME SETTING
Use the DIP switch at the back of the sounder body to select the output volume; in particular, switches 6 and 7, highlighted in picture 13, are
used.
The switches positioned upwards acquire value
“1”;
on the other hand, if positioned downwards acquire value
“0”.
1)
Select the alarm volume required when the sounder is activated (table 2).
2)
Refer to the corresponding line of the
“
DIP configuration
”
column to set the two volume selection switches.
Tone volume
DIP configuration
-
switch 6 and 7
dB(A) evaluation
Notes
HIGH
11
100 dB(A) +/
-
3
All tones
MEDIUM HIGH
01
MEDIUM LOW
10
LOW
00
Picture 12
Picture 13
Table 2
L20
-
CWSXX
-
1400 (vA.6)
