深圳市宏宇达数控技术有限公司
地址：深圳市南山区中山园路 1001 号 E4-6C(TCL 国际 E 城) TEL：755-26625800 FAX：755-26729960
-12-
2.3
、
XPTHC-4 Brake adjusting and sensitivity adjusting
DO NOT ADJUST THE RED SEALED!
XPTHC-4’s logic control is controlled by the SCM, it can be set on the operation panel,
and to raise up the high performance’s request, it uses the artificial circuit to control the
drive parts, so it can be adjusted the “R6012”(Brake-ADJ) and “R501”(SEN-ADJ) for the
motor’s brake and sensitivity. See Fig2-3 shows:
Fig 2-3 Brake and Sensitivity adjusting
1
、
To brake adjusting of the motor is to achieve fast braking when operate the THC
manually, then it can avoid the up/down distance due to the inertia, and makes the up/down
height more accuracy.
This THC (XPTHC-4) is to achieve the fast braking by Plug-Braking. It can be set via
adjusting the Resister “R6012(Brake-ADJ)”. While It has been adjusted well before
ex-factory, doesn’t need to adjust by user, unless longtime use/component aging etc. When
user adopts the motor control voltage to control the limit instead of using the THC’s limit
switch, it’s no effective of the fast braking function, please choose the proper limit method.
2
、
Sensitivity of THC decides the cutting accuracy.
THC sensitivity setting:
Sensitive increases on anti-clockwise, decrease on clockwise
Note:If sensitivity is too high, torch would shake, please test it carefully.
XPTHC-4 is tested on the 2800mm/min lifter,
so for 1000mm/min—3000mm/min speed
lifter, user no need to commission it. If user need the speed over 3000mm/min, then
could decrease the sensitivity a little lower according to the cutting situation(If it shake
during cutting, please decrease the sensitivity).
Sensitivity matters to the quality of lifter. If the lifter can lift torch up/down on with DC
motor Power Supply below 3V, it is qualify lifter for XPTHC-4.
Brake-ADJ
(Brake adjusting)
SEN-ADJ
(Sensitivity adjusting)
