HydroTherm DYNAMIC/X8, Owner'S Manual

Page: 7 / 33

7
3.0 INSTALLATION INSTRUCTIONS
3.1 DELIVERY
• Hydrotherm heat pumps must be stored and transported in a near vertical position at all times with
a tilt ratio of no more than 30°. Transporting or storing the unit in a horizontal position will void warranty.
• The system should always be transported in it's packaging.
• The weight of the package system is 145kg (139kg unpacked). The system must be handled by
two people at all times to avoid unnecessary strain and damaged.
• Please note the outer casing of the unit is susceptible to denting and damage. Care and
consideration should be taken into account when moving the unit as any marks caused by
inappropriate handling are not deemed as defects and are not covered under warranty.
Do not tilt
beyond 30°
Pallet for
transport only
All Hydrotherm heat pumps are designed for installation by a licensed plumber in accordance with
standards set out in AS/NZS 3500.2 “National Plumbing and Drainage Code Hot Water Supply
Systems - Acceptable Solutions”
.
The DYNAMIC X8 uses a flammable gas, therefore:
- The appliance should not be stored or transported in an area with an ignition source (eg. open
flame).
- Do no pierce or burn the appliance.
- Be aware that the refrigerant may not cause an odour.
- Compliance with AS/NZS 5601 must be observed while storing the appliance.
National and state regulations exist for the storage, transportation and handling of
hazardous goods including flammable gasses. The maximum number of and configuration of the
equipment permitted to be transported or stored together will be determined by the appliance
regualtions.