10
H16P USER MANUAL EDITION II 2017-05-18
4.5 Crimping
1.
When the die set is inserted in the machine and the crimping measurement set,
place the hose/pipe application between the dies. Ensure that all dies are
correctly inserted in the machine.
2.
The crimping diameter is reached when the indication lamp lights.
See below photo.
3.
Make sure that the crimping was correct and make adjustments if necessary.
5. Maintenance
5.1 Lubrication
The machine should be cleaned and lubricated every eight (8) operation hours. Retract the
dies to lubricate. Use a small brush to lubricate the cone shaped surfaces in the cylinder.
Better to lubricate sparingly and more often than seldom and excessively. Without lubrica-
tion, the machine looses power and you will damage the sliding surfaces.
Use only the lubrication recommended by Hydroscand Machine AB: Optimol viscogen 4.
