Hydronix Hydro-MIX XT Skid, Installation Manual

Page: 21 / 25

Hydro-Mix XT Skid Installation Guide HD0927 Rev: 1.0.0 21
Chapter 3 Troubleshooting
The following table list some common issues encountered with the Hydro-Skid. If you are unable to
diagnose the problem from the information, please contact your local distributor or the Hydronix
technical support team on: +44(0)1483 468900 or by e-mail: support@hydronix.com .
Symptom Possible cause Action required
No change in
sensor reading
during operation.
Sensor not in contact with
the material.
Adjust the height of the
Hydro-Mix XT Skid.
Maintain minimum gap of
50mm from the conveyor
belt.
Sensor signal is
unstable
Sensor not fully in contact
with the material
Adjust the height of the
Hydro-Mix XT Skid.
Maintain minimum gap of
50mm from the conveyor
belt.
Material build-up
on the sensor
under the Hydro-
Mix XT Skid.
Sensor not installed flush
with the underside of the
Hydro-Mix XT Skid. Adjust the position of the
sensor.
Material flows
over the top of the
Hydro-Mix XT
Skid covering the
sensor
Material level in front of
the Hydro-Mix XT Skid is
too high
Adjust the Hydro-Mix XT
Skid away from the
conveyor, ensuring the
sensor is in contact with the
material. Alternatively,
install levelling
plates/chains to reduce the
height
Sensor reading is
not close to zero
when the belt is
empty.
Hydro-Mix XT Skid is too
close to the belt.
Adjust the Height until the
reading is close to zero.
See section 3.3.