Hydronix Hydro-MIX XT Skid, Installation Manual

Page: 16 / 25

Mechanical Installation Chapter 2
16 Hydro-Mix XT Skid Installation Guide HD0927 Rev: 1.0.0
Sensor adjusted too low
Sensor flush with the underside of
the Sensor Plate
Figure 6: Correct Sensor Adjustment
3.3
Installing the Hydro-Mix XT Skid on a Conveyor Belt
The Hydro-Mix XT Skid should be installed above the conveyor attached firmly to a user
supplied suitable square bar (recommended size: 50mm x 50mm). The Hydro-Mix XT Skid is
attached to the square bar using the Mounting plate and Clamp Plate. The Hydro-Mix XT Skid
must be installed so it faces the material flow. For correct operation, the Hydro-Mix XT Skid
must be installed parallel to the conveyor belt. The square bar can be installed so it is parallel
to the belt or perpendicular.
Square Bar
(User Supplied)
Clamp Plate
Mounting Plate
M10 Bolt, Nut
and Spring
washer
M12 Nut
Figure 7: Correct Installation of the Hydro-Mix XT Skid